also that is a baseplate lol, but the changes I made to my model seemed to have fixed it for the most part.

Thank you. You were correct and I suppose my hunch was pretty accurate. The indentation I made was too small in diameter. I updated the model and I’m printing it again right now. Thank you very much for this reference.

Thanks. The OG slim chargy is for a g17 g19 so as far as I know, there is no existing file for a g43. I think I mistaken the Channel liner for the firing pin sleeve. The plastic almost circle that sets into the center depression is the firing pin sleeve? The lips seem to be very smooth the way they were printed, but I may also be defining the wrong part as the “lips” lol

I have exclusively printed all my builds in PPA-CF from sirayatech and they’re absolutely flawless. Super clean, super strong. Can’t go wrong once you get it dialed in. I have a few builds in PPS-CF CORE the stuff that sounds like metal when flicked and that was more for the novelty effect, but they’re also stupidly strong and high temp rated. I almost don’t want to use any other material outside of PPA-cf.