So after one thrown out back and an hour on the floor due to getting old, I can confirm that the remnants trip bar does work with the db9 alloy super safety lower by you. I need to bend the back trip area a few more degrees as its on the very edge of the super safety but other than that, my function tests are going good. Thanks again for responding

What I’ll probably do is if this trip bar for some reason doesn’t work, then I’ll just order new ones with the correct version this time and then get some levers cut from send cut send as well from some material.

Sounds good, ill try it at some point soon as I haven’t modified the upper yet and cut out that piece in the back. Also waiting on filament for the super safety lever for the mac

Also for remnants trip bar im assuming i bend the front as well around the curve of the bolt and not like yours is since its missing the extra tab at the front?

So long story short you’re saying the metal trip bar (which I ordered on send cut send) from the remnants (Mike???) mac daddy super safety system DOES work with your (PhoenixDesigns/AlexPhoenix) SS DB Alloy, they just bend in different ways and are different shapes but overall get the same function done?

Also you say the rear bend angle is different on remnants, can I use that bend angle in the SS DB Alloy or does it have to be different?