So I’m trying to see if I messed up or not. My hopes are high but I downloaded the “MAC Super Safety System” off odysee. I ordered from send cut send around 14 trip bars, 10 out of SS304 and 4 out of titanium.
The folder structure has led me to believe that this trip bar will work with the MacDaddy AND DB9 Alloy because of the read me file in there that says the following:
"-This DB Alloy remix ONLY works with the sheet metal trip bar design, not the printed trip bar (due to limited space in the lower design).
-The remixed designs included here were tested within beta. There are extra trunnions and different remixed lowers on the Phoenix Designworks Odysee page for those interested in other lowers not officially tested within the beta for this release."
This is not in the original phoenix designworks folder anywhere and the fact that it says “ONLY works with the sheet metal trip bar design, not the printed trip bar” tells me that it should work with the DB9 alloy as there is no printed trip bar in the phoenox designworks folder at all.
I also swear I remember seeing on r/Fosscad that people were using the MAC Super Safety System with the DB9 alloy but obviously I can’t check because it’s gone now.
If anyone has any information please let me know or else I’m just gonna dive into this blind and hope it works.
i highly recommend the metal ss lever from DNT but i’m sure the right material would hold up pretty good. and correct, the front just wraps around the front of the bolt. the little tab on my short trip is so it can interface with the breech face but remnants trip uses the front of the bolt.
So after one thrown out back and an hour on the floor due to getting old, I can confirm that the remnants trip bar does work with the db9 alloy super safety lower by you. I need to bend the back trip area a few more degrees as its on the very edge of the super safety but other than that, my function tests are going good. Thanks again for responding
What I’ll probably do is if this trip bar for some reason doesn’t work, then I’ll just order new ones with the correct version this time and then get some levers cut from send cut send as well from some material.