Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)T

techgundam

@ techgundam @forum.guncadindex.com

Posts
0
Comments
2
Joined
10 mo. ago

  • P1S Firmware Versions?

    Jump

  • 1.7 is the last version to work reliably with orcaslicer. 1.8 still allows non-bambu services to connect, but prints from orcaslicer don't start. 1.9 is locked down unless you go LAN only.