I haven’t gotten any threaded rods yet since I’m gonna be getting the aluminum trunion from Riptide, and they for whatever reason, don’t list what the machined threads are in the trunion. Thus, I’m waiting until it arrives.

However, today I was able to go back and work on the thing, the KAK barrel measured out to be 22.84mm at that one section and the physical print I measured around 22.6mm.

I shoved the barrel into the hole the wrong way and then hammered it through with a nylon mallet until it sheared off a thin layer of plastic, it fits fine now lmao, problem solved!

I can see from photos online that the gen 2 doesn’t have the upper support pin on the locking block, you should be able to use the frame without it on 9mm. What doesn’t work?