Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)D

davidwebb

@ davidwebb @forum.guncadindex.com

Posts
1
Comments
4
Joined
2 mo. ago

  • Issues about fgc

    Jump

  • helps

  • General Discussion @forum.guncadindex.com
    davidwebb

    Issues about fgc

    I've disassembled and reassembled the retainer 4-5 times to resolve some issues. The last time I installed it, I tightened the screws less force than the first time, and there was no squeaking. (It still requires some force.) I know plastic threads are prone to failure; in this case, is it still safe to use it, or should I re-print it?

  • Deleted

    Permanently Deleted

    Jump

  • Useful matal just floating on the top maybe 2mm. Down there is all welding slag.no connection between two parts. This one is wasted one. The one I'm using is slightly better then this

  • Deleted

    Permanently Deleted

    Jump
  • Deleted

    fgc feeding issue

    Jump

  • bolt face, pick up bubble flat and squre.feed ramp have reprinted looks ok,no touch with firing pin.