So after one thrown out back and an hour on the floor due to getting old, I can confirm that the remnants trip bar does work with the db9 alloy super safety lower by you. I need to bend the back trip area a few more degrees as its on the very edge of the super safety but other than that, my function tests are going good. Thanks again for responding
- Posts
- 2
- Comments
- 5
- Joined
- 3 mo. ago
- Posts
- 2
- Comments
- 5
- Joined
- 3 mo. ago
Help & Support @forum.guncadindex.com Mac Super safety question
So I'm trying to see if I messed up or not. My hopes are high but I downloaded the "MAC Super Safety System" off odysee. I ordered from send cut send around 14 trip bars, 10 out of SS304 and 4 out of titanium.
The folder structure has led me to believe that this trip bar will work with the MacDaddy AND DB9 Alloy because of the read me file in there that says the following:
"-This DB Alloy remix ONLY works with the sheet metal trip bar design, not the printed trip bar (due to limited space in the lower design).
-The remixed designs included here were tested within beta. There are extra trunnions and different remixed lowers on the Phoenix Designworks Odysee page for those interested in other lowers not officially tested within the beta for this release."
This is not in the original phoenix designworks folder anywhere and the fact that it says "ONLY works with the sheet metal trip bar design, not the printed trip bar" tells me that it should work with the DB9 alloy as there is no p
Help & Support @forum.guncadindex.com Kabuto troubleshooting
I tried this when it first dropped, didn't work and I just got around to trying it again as I need to order some things from SCS and I like this design but I can never get the Kabuto TURD to work. I don't know what I'm doing wrong but this is as far back as the BCG will go. I tried pulling it back further and when I did, it locked up and had to push the rear takedown pin out, let a small gap pop up and the BCG flew forward.
I just can't get anywhere with this. I'm going to try the Kev remix as it takes milspec 3 pos but I wanted to see if this worked to begin with, which it didn't.
I have both a P1S and an older Q1 and love my Q1. I haven't printed with any fiber filaments yet because I'm lazy and don't feel like it but I will be printing with Bambu PAHT-CF sometime this week for some super safety mac levers and will be using my Q1 (Q2 is just the Q1 with better appearance, hotend temps, chamber temps, and probably build) due to the heated chamber specifically. I have printed ASA a bunch and its always great. You never know how much you want/need a heater chamber until you need to print it with it. Also on the Q1 (not sure about the Q2) has hardened gears and a bimetal hotend (nickle plated copper with a hardened steel tip) from the factory whereas the P1S you have to buy an extra nozzle and gears (If you buy complete hotend its like $35 and the gears are $20). Just something to add to the price.