Thanks for the info. Ill give this is shot and run my print tonight and report back in the morning on the results!
- Posts
- 1
- Comments
- 2
- Joined
- 3 mo. ago
- Posts
- 1
- Comments
- 2
- Joined
- 3 mo. ago
General Discussion @forum.guncadindex.com Help with PLA Pro and X1 Carbon
Trying to dial in my settings on my X1C. The first print I worked but the finish looks horrible. I know I had the speed way to high then the recommended for Polymaker PLA Pro. This is what I have it dialed down to for my 2nd attempt. Looking for some insight from other X1C users to help tweek what I have. Thanks!
So reprtinted over night. Still had some of the same issues. I did notice that the desk I am using it on does wobble a shit ton when printing. Not sure it would have that much affect but I do have a decent amount of z banding going on it seems. Went out and bought a concreate slab to put it on and will see if that helps a bit.