Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)T

Therustynut

@ Therustynut @forum.guncadindex.com

Posts
3
Comments
5
Joined
1 mo. ago

  • Newbie question - I would like to try Meshtastic

    Jump

  • Dumb question, g19

    Jump

  • IIRC the holes need to be drilled too the size of the pins. Ill bring home my good drill bits.

  • annealing PA612CF

    Jump

  • Im impressed. It's fibron. I'll order some salt and let it hang out in its naked glory.

  • annealing PA612CF

    Jump

  • flower salt not sure of what that is,? I was going too anneal in the air firer, same one for drying PA.

    Edit, is there a need too add moisture into the print afterwards? Im still a bit new to PACF

    ok, did some reading. so can i get away with a dish of regular table salt. then 100c for a whopping 16 hrs? damn.

  • General Discussion @forum.guncadindex.com
    Therustynut

    "law tactical" style AR adapter.

    Has anyone tried a law tactical style adapter? Pretty sure it couldn't be made all that sturdy considering the stresses on the component. I'm making a sl9 and was tempted too make it as short as possible.

  • Help & Support @forum.guncadindex.com
    Therustynut

    annealing PA612CF

    I have a hoffman sl9 running in the bambu as I type. Whats some preferred tips and tricks for annealing. Ive heard the obvious temp and time. Do I leave the supports on while its cooking? thanks.

    oh yeah, FUCK Reddit.