Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)O

OpenPew

@ OpenPew @forum.guncadindex.com

Posts
6
Comments
7
Joined
3 mo. ago

  • Suppressor Material

    Jump

  • Ditto to everything @kopsis said except the part about annealing. Yes annealing will help. But I’ve had more noticeable strength improvements from moisture treatment over annealing -particularly layer adhesion. The wet sponge in bag method for a few days works quite well.

    If you have the time and equipment to do both annealing and moisture treatment, do it.

  • Who makes the best AR-15 pistol brace?

    Jump

  • In terms of models I recommend the APB3 on the bambu app. There may be a reupload on Odysee. The only mod I did was print the pin out of pacf SIDEWAYS instead of vertically. Good luck

  • Guncad Digest Issue #10: Pump .308, Printable Deagle, Hybrid 15mm Shells, FOSSCAD Social Media Purge

    Jump

  • Ser, just wanted to say thank you for you work putting these together consistently. Grateful to have been featured this latest edition but even when my designs aren’t, I enjoy catching up on things I missed when these come out. Especially valuable now that Reddit is dead to us, making the information more scattered

  • Deleted

    Permanently Deleted

    Jump

  • I’ve never heard of legit decibel readings for the ftn cans (or any 3dp can I know of lol). The problem is getting ahold of a decibel meter that can measure quick enough pressure impulses, and they are thousands of dollars. Phone microphones just don’t respond fast enough to the microseconds long pressure waves of a gun shot. Would be amazing to develop some sort of diy way to just ballpark it though - maybe some bursting pressure caps of increasing toughness… can’t be that hard considering the big magnitude difference in pressure between even eg 130 and 136 db

  • FPV community?

    Jump

  • YES

  • OP22-A is Sailing (fully printed 5.7 & 22 can)

    Jump

  • The tester who ran it on his psa rock said it cycled well. Chat on matrix?

  • General Discussion @forum.guncadindex.com
    OpenPew

    OP22-A is Sailing (fully printed 5.7 & 22 can)

  • Suppressors @forum.guncadindex.com
    OpenPew

    OP22-A is Sailing (fully printed 5.7 & 22 can)

  • Suppressors @forum.guncadindex.com
    OpenPew

    Kicking off /c/suppressors with 2 minutes left in Suppressor Sunday!!