Lowest durable material possible for FTN4/5?
Since Tax stamps are $0, I'd like to file a Form 1 to make one, but since I have no enclosure for my printer, I'm wondering what's the lowest durable material I should attempt to print in? Is PLA+ durable enough? I've read each documentation extensively and I'm seeing PA6-CF is what was tested, so I'm not sure should I just sit this one out until I can upgrade printers?
DB Alloy Feed Issues
Hey All,
Went to the range the other day to finally test my DB Alloy build. Before I ever got to the shooting phase, I had issues with the printed Sten mags, so I decided to buy a few surplus mags from Atlantic Firearms. So I got my mags, polished them up, put a little lube around the follower and what not. The mags work fine outside the gun itself.
Got to the range, loaded up my mags, and when I pulled the charging handle, it seems like it is double feeding. The bolt charges two bullets instead of the one. Whatever, tried another mag, same thing. I'm thinking this is on the mags.
Any suggestions?
No you're right, I misread.
Also, everywhere I read says that when printing PA6-CF, an enclosure is heavily recommended. My SV06 barely reaches high enough nozzle temps as it is. So that is my excuse. Unless I'm wrong? IDK, I've had a few issues with the SV06 printing PLA+ already, I doubt its good enough for PA6-CF.