FTN 5 Reinforcement

With PLABoi removing his Odysee, does anyone have the instructions for reinforcing the FTN 5? I could probably figure it out but I'd feel better if I followed the original instructions.

Specifically, these:

• JB weld + aluminum or CF tube (see pdf/vids here https://odysee.com/@Plaboi:2/FTN.4-Suppressor-Pack:6)

• 3M casting tape + epoxy resin (https://odysee.com/@Plaboi:2/strongest3M:4)

• fiberglass sleeve + epoxy resin (https://odysee.com/@Plaboi:2/Video-(4):51)

• fiberglass sheet + epoxy resin (https://odysee.com/@Plaboi:2/Video-(2):72)