https://www.youtube.com/watch?v=bzf1yP6HUmY
I’m getting errors trying to create a pocket (2:25) because one of the edges of the inner rectangle is right on top of the outer rectangle, and I can’t select just the inner rectangle
You must log in or # to comment.
Not enough info and I’m about to go to bed. Easiest is delete and start again. You need to constrain geometry better than tutorials tend to show. I have never seen someone show proper topological design in tutorials either.
The main issue in cad is always π. When there are problems, think about where π is potentially being truncated to constrain a vertex. All geometry in cad is built sequentially
