Since the SF5 was released, have there been any significant updates/changes? I built one a while back but the super safety indent would wobble no matter what. The additional play in the indent would allow the cam to slide to ‘safe’ while firing quickly. I’d like to rebuild it so the SS works reliably.

    1. has anyone else had this problem and have any suggestions to fix it?
    1. have there been any good SF5 alternates/remixes that I could print instead?

I figure if I need to reprint the lower again, might as well see if there are any new designs. -

  • redditmosquitoEnglish
    3·
    5 days ago

    I made a new lower that is grip integrated, but I won’t be uploading it soon due to it being poly modeled. One thing I noticed about the safety detent is that the hole is either misaligned on accident or purposely.

    Many times when drilling the detent hole do I accidentally bust a hole on the side wall making the detent not so snappy

    • Dwalk51@fosscad.ioOPEnglish
      1·
      2 days ago

      Yep, like it’s too close to the wall. I’ve even tried over sizing the hole and then using a metal liner to hold it perfectly even to no avail.