Trying to dial in my settings on my X1C. The first print I worked but the finish looks horrible. I know I had the speed way to high then the recommended for Polymaker PLA Pro. This is what I have it dialed down to for my 2nd attempt. Looking for some insight from other X1C users to help tweek what I have. Thanks!
Thanks for the info. Ill give this is shot and run my print tonight and report back in the morning on the results!
So reprtinted over night. Still had some of the same issues. I did notice that the desk I am using it on does wobble a shit ton when printing. Not sure it would have that much affect but I do have a decent amount of z banding going on it seems. Went out and bought a concreate slab to put it on and will see if that helps a bit.
Lots of possible causes for z-banding. This article does a pretty good job of breaking them down: https://all3dp.com/2/z-banding-z-wobble-fix/