HELP: Threaded hole printing too large/loose

Tested a print of a muzzle device after calibrating some PLA Pro. The print came out looking great. However, the 1/2x28 threads in the ID are very loose, so much that with minimal force, you can pull straight past them.

So, I've seen a few different ways to fix this, but I wanted to see what the community agrees to as the "best" practice to adhere to.

Do I adjust for shrinkage, add in additional tolerance in the modeled threads, or do something else entirely?

Bambu P1S

0.4mm Nozzle

0.16mm Layer Height

Overture PLA Pro