Looking to finally make the jump from my old Ender 3 to a better printer, I’ve upgraded the Ender quite a lot but have run into multiple problems over the years with custom firmwares. During my last move, I snapped the SD card slot off the main board and have had issues getting the new one back up and running. With all of that said I’m ready to just buy once, cry once, and get back to printing.

The options I’m looking at are either the X1C or the P1S. I wanted to get opinions here, as from what I’ve found so far, the P1S seems to have the same print speed/quality, just minus the AI, and upgraded steel components. How capable is the P1S stock, and what upgrades, if any, would be recommended?

From what I’ve found, the AMS 2 seems to be the ideal choice over the OG AMS due to the drying function and more user-friendly design. It’s $120 more for the AMS 2 combo than the AMS combo, so for those of you who have these setups, is the AMS 2 worth it?

Other than the printer selection, what are your go-to filaments and brands? I’ve seen PPA-CF, PA6-CF, and PAHT-CF mentioned, but don’t really understand the pros and cons of each.

I was a long-time lurker on the Fosscad sub, but I am hoping to contribute moving forward.

  • AproxieEnglish
    2·
    3 days ago

    Look for the micro Swiss diamond nozzle upgrade. You can get a p1s producing better output than a stock x1c. And I’ve got 2 X1C’s saying this

    • RenegadeSCOPEnglish
      1·
      3 days ago

      So is the micro Swiss the better option? The hardened steel options from Bambu labs seem to be the cheapest, followed by BTT with theirs that is quick change, with the micro Swiss being the most expensive with the diamond tips.