I printed some dimensional blocks and got the exact opposite results i was expecting. The pla+ block came out slightly smaller than the set dimensions and the pa6-cf block was actually slightly larger than the set dimensions.

How do i address this. I guess it could make some sense as its the openings in the prints that are too small so the pa6-cf test print being larger could mean that the negative space is being taken up by this but if i scale the print larger to increase the hole sizes then the rest of the print will be too big.

thanks everyone for pointing out the obvious of how to test the calibration i was more or less asking if its normal for PA6 to shrink more than PLA +