Hey everyone,

I’ve got a grip design that’s ready for beta testing.

It is only ~10 degrees off from perfectly vertical, so the hole for the grip screw would normally end up right in the middle of the backstrap. To get around this, I made the backstrap a separate component that is pressed into the front of the grip after being screwed onto the receiver. This also allows you to easily make the grip two-tone or potentially print the rear in a firm rubbery material for extra comfort.

  • DINGOEnglish
    2·
    2 months ago

    Nice work. I like the idea of being able to swap out the backstrap with an alternate material. Is ASA a good material for printing things like grips, foregrips, stock parts, etc? I’ve been wanting to save my Nylon for frames and don’t like PLA+ all that much.

    • Simon_COPEnglish
      1·
      2 months ago

      I just printed the prototypes with plain old PLA. ASA should work fine.

    • Simon_COPEnglish
      2·
      2 months ago

      I’m not quite sure the exact procedure people use on this website, to be honest. If you’re on the deterrence dispensed chat, the beta files are already up there

  • Simon_COPEnglish
    1·
    1 month ago

    Beta testing is going well. Will launch shortly.