The plastikov has features which make it look like a FA sear could be made to work but, it won’t fit as is. FA also requires a factory FA selector to hold the FA disconnector tail down.
Damn I was thinking that there was enough room for the sear but wasn’t sure about them safety being an issue or not. Do you think it would be possible to modify the safety on the plastikov? It doesn’t seem like it would be too hard to do.
There’s a girl close to where the sear goes but it’s not in the exact location.
Wouldn’t be too hard to mod the selector for three position binary, but getting a FRT work will take a lot of time on both the frame and the trigger housing.
The plastikov has features which make it look like a FA sear could be made to work but, it won’t fit as is. FA also requires a factory FA selector to hold the FA disconnector tail down.
Damn I was thinking that there was enough room for the sear but wasn’t sure about them safety being an issue or not. Do you think it would be possible to modify the safety on the plastikov? It doesn’t seem like it would be too hard to do.
There’s a girl close to where the sear goes but it’s not in the exact location.
Wouldn’t be too hard to mod the selector for three position binary, but getting a FRT work will take a lot of time on both the frame and the trigger housing.